One of the things you shouldn't be without is having a working windshield washer fluid. We think first of all about driving comfort, but it is important to know that this also involves your safety behind the wheel because of the importance of seeing very clearly in front of you when you are driving your Citroen Jumper 2.
In this article, we are going to explain step by step how to identify the fault and resolve it in order to find an effective windshield washer.

washer-who-works-pluscitroen-jumper-2

Different steps to repair a windshield washer that does not work on a Citroen Jumper 2

You have various essential steps in order to be able to repair the washer fluid of your Citroen Jumper 2 which no longer works.

Identify the washer failure:

Before you start, have you completed your cleaning fluid ? If this is the case, let's move on to identify the causes that do not allow the proper functioning of your ice washer equipment.

Very often, your ice washer equipment becomes clogged with accumulated dirt or lime, this is the main reason that would prevent your hardware from working. To remedy this, you must unclog your jets. These orifices are used to propel the washer fluid onto the windshield of your Citroen Jumper 2. There is a good chance that they are clogged, by lime storage, or simply various dirt. To remedy this, try blowing, yourself or with something more powerful, such as a bicycle pump or even ideally the tire inflator at your gas station.
If nothing helps, try with a thin and resistant object, like a paperclip for example, which will allow you to access the interior without losing a piece. We recommend that you also use a mixture of vinegar and hot water in order to clean the interior more effectively.
Test again, if nothing comes out, maybe it's clogged in a deeper place, at the level of the connecting pipe. Its role is to make the link between the pump and the nozzle.
To reach it, you will have to open the hood of your Citroen Jumper 2:
You should target two pipes specific to each nozzle. Try to clean them and of course make sure they are well connected. You can repeat the same cleaning processes that we told you about above. When they are cleaned, you should be able to circulate water through them without a hitch. Then reconnect them properly, and repeat the test. If this still does not work, you suddenly know that it is neither the jets nor the pipes on your Citroen Jumper 2.

Check the washer pump

From this point on, you should then check the pump. It is she who initiates the launch of the cleaning product.
You will find it near the cleaning liquid tank under the hood of your Citroen Jumper 2.
First thing to do to test if it works, when you activate the windshield washer when you want, there should be a pumping noise. In the absence of noise, this implies that it does not work. It will then have to be changed.
For that, it's very simple. First of all, you will have to remove the two screws that allow it to be fixed to your Citroen Jumper 2.
Thereafter, you must identify two power wires. They are most often black and red. You will have to unplug them, but be careful, you will have to reconnect them in the right direction once finished in which case you will create a short circuit. A little trick to remember: the red wire represents the + terminal. Simply stick a piece of red tape on it to be sure to find it. Or even logical with the black tape on the terminal -. Thanks to this, you will avoid the short circuit caused by a negative wire connected to the positive terminal.
Once done, you can remove the old pump and place the new pump. Reconnect the cables correctly using the trick, then you just have to tighten the two retaining screws.
Test the mechanism again.
Everything should be back to normal by now!